Ben and Kathy
Well-known member
Renogy flexible panels for weight reduction.What type of panel are you using on the roof? Metal or plastic?
Renogy flexible panels for weight reduction.What type of panel are you using on the roof? Metal or plastic?
Ya, basically. I ran the wires to the front wall, then toward the door side wall and penetrated into the front storage
compartment at the top corner.
Sorry I was not refering to solar panels I was refering to junction box. Thank you for a response though. 🙂Renogy flexible panels for weight reduction.
Opps, box is plastic, got it off Amazon hereSorry I was not refering to solar panels I was refering to junction box. Thank you for a response though. 🙂
You can remove the light by the door to access the wirenutted wires at the roof gland. I did mine in the spring after someone posted about their wire burning up.Now I’m worried about the solar prewire in my 32rls.The cable up on the roof gland is 10 awg but transitions to 8 awg in the front compartment.I sure hope the didn’t use wire nuts for the splices!I guess I will be pulling wires.
They're using butt connectorsWonder what the "new connector" being installed is? When I gave mine a gentle tug to see if there was some slack I could utilize, the wire just pulled right out. Connection must not have been tight at all. Just ended up abandoning the roof gland.
What light is by the door or are you referring to the control panel by the door?You can remove the light by the door to access the wirenutted wires at the roof gland. I did mine in the spring after someone posted about their wire burning up.
The light in the ceiling between island and tableWhat light is by the door or are you referring to the control panel by the door?
Thanks,The light in the ceiling between island and table
Me wonders if the 2024’s were made with the butt connectors or just left off the recall.Just a note that a recall has been issued on this
Going outside to turn my solar off.......