• Click here to access some of the presentations made during the 2022 National Rally

Microwave Suffocated in 292RL

Bruco

New member
The Greystone microwave in our brand new 2026 Delta 292RL is operating exactly as it should. By this I mean its thermal device is interrupting power long enough for the unit to cool. This is a safety feature designed into every brand of microwave product. The problem in our 292RL is that the appliance placement in the cabinet's cavity does not offer any space for the heat to escape. Thinking this can be a simple fix involving trim work to provide venting. Anyone have suggestions?
 

Attachments

  • IMG_3771.jpeg
    IMG_3771.jpeg
    1.6 MB · Views: 17

Oregon_Camper

Forum Admin
Staff member
On our 340RL, there is a factory vent. I have seen others without a vent and it just dumps the air back into the cabinet. During the last National Rally and one PNW Rally, there was a service offered that would install a vent in your RV.
 

BryanValRox

Elite Member
The Greystone microwave in our brand new 2026 Delta 292RL is operating exactly as it should. By this I mean its thermal device is interrupting power long enough for the unit to cool. This is a safety feature designed into every brand of microwave product. The problem in our 292RL is that the appliance placement in the cabinet's cavity does not offer any space for the heat to escape. Thinking this can be a simple fix involving trim work to provide venting. Anyone have suggestions?
Good morning,
Out of complete curiosity, how long do you need to run the microwave for it to trip out on the thermal limit?
Is there anything in the manual that calls out clearance requirements for heat ventilation?
 

M and E

Prominent Member
The Greystone microwave in our brand new 2026 Delta 292RL is operating exactly as it should. By this I mean its thermal device is interrupting power long enough for the unit to cool. This is a safety feature designed into every brand of microwave product. The problem in our 292RL is that the appliance placement in the cabinet's cavity does not offer any space for the heat to escape. Thinking this can be a simple fix involving trim work to provide venting. Anyone have suggestions?
Is it ducted? If it is and the TC is tripping, I can almost promise that they have the vent ducting orientation wrong (vertical vs horizontal vs recirculating). If it is not ducted then it has to be in the recirculate mode.

Does it only happen after the stovetop or oven has been operating or does it cutoff say making a bag of popcorn?
 
I am having the same issue with our 2026 292rl. It feels like there are vent holes in the bottom and on the right side of the metal trim, but not feeling any real airflow. Trying to pop popcorn (3 minutes) trips it. It is happening for me without any use of the stovetop - so no additional heat.
 

BryanValRox

Elite Member
I am having the same issue with our 2026 292rl. It feels like there are vent holes in the bottom and on the right side of the metal trim, but not feeling any real airflow. Trying to pop popcorn (3 minutes) trips it. It is happening for me without any use of the stovetop - so no additional heat.
Check your fan ducting for proper installation. Most microwaves that have an exhaust fan have changeable ductwork.
one orientation allows for air to be vented to the outside via a flapper in the wall, the other orientation allows for recirculation into the camper. If the duct work(baffle) isn’t correct, it could cause issues with ventilation.
 

RockDr896

Well-known member
If the microwave is convection as well, I ran into this with my microwave at my house. The mounting screws were keeping the units safety latch/safety switch from fully engaging. The unit would try to microwave, but the switch would shut off that feature. It would convection cook, but not microwave.

Probably not your issue, due to how it is mounted in an RV. I did get to practice my typing though
 

Attachments

  • 1781012733070.png
    1781012733070.png
    766.9 KB · Views: 2
Check your fan ducting for proper installation. Most microwaves that have an exhaust fan have changeable ductwork.
one orientation allows for air to be vented to the outside via a flapper in the wall, the other orientation allows for recirculation into the camper. If the duct work(baffle) isn’t correct, it could cause issues with ventilation.
There is a flapper in the wall, but I assumed that was for the fan over the stove. Once the microwave tripped the thermal circuit, I also lost the fridge (2nd time it has stopped working). Super frustrating - then the next day the fridge was on again (not cooling very well, but running). So I am assuming there is a thermal issue there as well? Not sure if the fridge and microwave are both venting into the same cavity on the slide, and that is what is causing issues?
 

BryanValRox

Elite Member
There is a flapper in the wall, but I assumed that was for the fan over the stove. Once the microwave tripped the thermal circuit, I also lost the fridge (2nd time it has stopped working). Super frustrating - then the next day the fridge was on again (not cooling very well, but running). So I am assuming there is a thermal issue there as well? Not sure if the fridge and microwave are both venting into the same cavity on the slide, and that is what is causing issues?
You are correct, the stove vent, which is part of the microwave vents thru a wall flapper. I have to unlatch the flapper as part of our set up process and snap it back shut during tear down.

I just offered the suggestion thinking that the same air passages could be used to allow some hot are to escape instead of dead head to know where. A quick check to see if your flapper is open and or functional is just turn the vent fan on and see if air is exiting outside at the flapper.

Simple checks.
 
You are correct, the stove vent, which is part of the microwave vents thru a wall flapper. I have to unlatch the flapper as part of our set up process and snap it back shut during tear down.

I just offered the suggestion thinking that the same air passages could be used to allow some hot are to escape instead of dead head to know where. A quick check to see if your flapper is open and or functional is just turn the vent fan on and see if air is exiting outside at the flapper.

Simple checks.
Gotcha - we are new to the RV scene - my tent never had microwave venting issues. :)
So the microwave does vent through the fan flapper?
 
Top