Ray & Dawn Karl
Active member
Looking to replace all the grease fittings on the wet bolts. anyone know what thread sizes they are..
Thank
Ray
Thank
Ray
Grease Fitting Size
- Thread starter Ray & Dawn Karl
- Start date
Focker
Well-known member
In my case on my Valor they were metric, M6 - 1.0.
To find out the size of your grease fittings Morryde says if a 5/16 socket fits over the zerk then it is 1/4-28 SAE and if a 5/16 does not fit then it is M6-1.0. The M6 fittings use a 7mm.
When I have time, I am just going to turn the bolts around so I can grease them without taking tires off or adding 45 or 90 fittings. They should have come from the factory facing inward.
To find out the size of your grease fittings Morryde says if a 5/16 socket fits over the zerk then it is 1/4-28 SAE and if a 5/16 does not fit then it is M6-1.0. The M6 fittings use a 7mm.
When I have time, I am just going to turn the bolts around so I can grease them without taking tires off or adding 45 or 90 fittings. They should have come from the factory facing inward.
Ray & Dawn Karl
Active member
Thanks, I have to look into maybe doing that too instead of replacing.