• Click here to access some of the presentations made during the 2022 National Rally

unLeveling Jack

1911LVR

1911LVR

Member
I noticed on my 2024 Avenue 37MBR that the two rear jacks are not at the same height where they bolt to the frame. The mount point is one hole difference between the two. I would think they should be equal. How big a deal is this? I could move it myself if I knew the torque spec.
 
BryanValRox

BryanValRox

Elite Member
1911LVR said:
I noticed on my 2024 Avenue 37MBR that the two rear jacks are not at the same height where they bolt to the frame. The mount point is one hole difference between the two. I would think they should be equal. How big a deal is this? I could move it myself if I knew the torque spec.
Click to expand...
Hello, I am not sure it is a big deal because level is level based on ground contact at a given point.
Yes, it would give those jacks more or less lift based on their relationship to the others.
Check out this link or the Appropriate website for the torques for your specific system if you choose to move it.
I would also suggest (just because 😂) if you move it, the you manual level and go thru the recalibration process for your system. It shouldn’t really matter because level is determined by a sensor and not the jacks, but hey, as simple as the process is it certainly can’t hurt.

 
R

rick 6621

Well-known member
The hole positioning should not make any difference level is level. One reason is maybe they had to drop one hole because to close to an obstruction.

2022 alliance avenue 30 rls
 
L

Lantley

Prominent Member
rick 6621 said:
The hole positioning should not make any difference level is level. One reason is maybe they had to drop one hole because to close to an obstruction.

2022 alliance avenue 30 rls
Click to expand...
I agree I have considered raising my jacks by one whole because they appear too low to the ground to me.
However, Maybe my thoughts on clearance are wrong years later so far so good on ground clearance.
Take a closer look maybe the jack maybe higher for a reason.
 
You must log in or register to reply here.
Top