Underbelly
- Thread starter SNadler11
- Start date
Should be able to remove 1 or 2 of the rivets Alliance uses to look in there. Then use screw (metal) to reattach.
Midnight Rider
Prominent Member
Is
Is there a size/type screw you recommend? I’d like to keep a few handy if I ever gotta get up under mine?
OC,
Is there a size/type screw you recommend? I’d like to keep a few handy if I ever gotta get up under mine?
Dang...I just tossed the box a week ago. Here are 3 pictures, showing you the size of the screw. Best to have an impact driver vs drill for this job
Chaseweston
Well-known member
I don't have the same model but looking at the floor plan and specs, it is highly likely what you are feeling the underbelly up against is the kitchen sink gray tank. Either pull some shot pins to peak in there to confirm, OR, empty your kitchen gray tank and push up on the underbelly at this location and see if it now pushes up more without as much water in the tank. It is actually pretty crazy how much the holding tanks deform when full. They really sag down in the middle of the tank.
Socal-Paul
Well-known member
I believe a #10 is what I used.
Chaseweston
Well-known member
#10 rings a bell for mine as well. I replaced them all across a few times pulling the underbelly for various reasons.
pro tip for shot pin removal: put a 1/4" tapcon bit on the head of it and spin it while you pry down with a flathead or small breaker bar. They pop out pretty easy like this.
pro tip for shot pin removal: put a 1/4" tapcon bit on the head of it and spin it while you pry down with a flathead or small breaker bar. They pop out pretty easy like this.