Likin' Bikin'
Active member
Recently adjusted our LR slideout, 2022 Paradigm 340RL. About 3/8" outward adjustment, to try and get floor out farther and reduce height at the interface. After arriving at next stop I told my wife I wanted to watch the slide operate, especially the end near the door. I stuck my head inside as I noticed some excessive movement (I thought) in the ski I just reinstalled. That is when I saw a gap between the floor and the side wall of the slide out, prob about 3/8", at the interior end. Went ahead and had my wife run the slide out, as I went from inside to out to monitor. The gap closed up, but it seems obvious the end wall is pulling loose at the bottom. Any ideas on what causing, and how to fix?
One pic shows the flooring pulling out from under the end wall. The others are to show resulting clearances with slide fully extended, and the location of the floor edge of the slide out.
One pic shows the flooring pulling out from under the end wall. The others are to show resulting clearances with slide fully extended, and the location of the floor edge of the slide out.