MORyd x-factor cross member bar

[Arendsonthego]

We have a Valor 40v13 and are putting 2 cross member bars on. The one that will go in the front has the grey tank pipes in the way. What would be the best way to put this on?

 

[BryanValRox]

We have a Valor 40v13 and are putting 2 cross member bars on. The one that will go in the front has the grey tank pipes in the way. What would be the best way to put this on?

Can you share more? Do you mean frame cross members, or some kind of accessory? Could you also share the why behind this? I am very courious.

 

[BryanValRox]

We have a Valor 40v13 and are putting 2 cross member bars on. The one that will go in the front has the grey tank pipes in the way. What would be the best way to put this on?

Ok, I found these on the web and understand their purpose. It looks like they make a drop down kit that should get you about 5 inches of clearance from your mounting point. If that doesn’t get you enough clearance, you should reach out to the manufacture for suggestions.

 

[Arendsonthego]

Ok, I found these on the web and understand their purpose. It looks like they make a drop down kit that should get you about 5 inches of clearance from your mounting point. If that doesn’t get you enough clearance, you should reach out to the manufacture for suggestions.

Sorry I could have been more specific. We are replacing our suspension with the Roadmaster Comfort Ride Slipper Spring with shocks. Along with that we are adding the MORyde x-factor cross member bars for more stabilization. One will go on the front spring hanger and that’s where the pipes are. Not sure if there’s a way to do it but we will take a look at the drop kit you mentioned. Thanks