Valor Garage Floor

[dpeterson2014]

Hello, I just purchased a 37V13 and want to add a motorcycle wheel chock bracket to floor. What is the best method to set 2 screws? The bracket would straddle the center L track towards the front of the garage. I’ve attached a photo of the bracket. Thanks in advance!

Sent from my iPhone using Tapatalk

 

[SteveCornell]

Hello, I just purchased a 37V13 and want to add a motorcycle wheel chock bracket to floor. What is the best method to set 2 screws? The bracket would straddle the center L track towards the front of the garage. I’ve attached a photo of the bracket. Thanks in advance!

Sent from my iPhone using Tapatalk

I would use one of these designed for the L track https://www.uscargocontrol.com/products/l-track-double-lug-threaded-stud-fitting

 

[dpeterson2014]

Thanks! I did review that product too but it’s not compatible with Condor, Pingle or other motorcycle chocks. I need to drill into the floor. I’ll contact the factory.


Sent from my iPhone using Tapatalk

 

[SteveCornell]

Thanks! I did review that product too but it’s not compatible with Condor, Pingle or other motorcycle chocks. I need to drill into the floor. I’ll contact the factory.


Sent from my iPhone using Tapatalk

If I were you I would purchase a 3\16" steel plate or 1\4" aluminum to mount your motorcycle chock to then attach that to the L track with the stud fittings I suggested, I would not drill into the floor.
There should be a metal supplier near you that can cut the metal plate to the exact size you need.

 

[Focker]

I use a Condor chock with a wood block in front of it to keep it from sliding forward. Just tie down and secure your bikes, nothing will go anywhere. I have been doing it this way for years in my toyhaulers and never needed anything to secure the chocks to the floor.

 

[dpeterson2014]

Ingenious thanks for feedback. I will look into these solutions!


Sent from my iPhone using Tapatalk