Shower Fixture Disassembly 390MP
- Thread starter divinIN
- Start date
Figured it out. I really don’t like this design at all. Each end is pressed into the middle black piece that the shower head hose screws into. You really have to wrench on each side to disconnect it. In doing so I cracked a piece of the shower backing. The holes were very sloppily done too. It doesn't look like a hole saw was used.
Attachments
Last edited:
Important Note: You should not have to unscrew the hot and cold valves (I guess that is what they are called) to clean them or check for blockage. If you do, you will likely unscrew a critical piece that will fall down inside the wall. See this thread for more info on my lesson learned there. https://alliancervowners.com/forum/threads/fixed-low-hot-water-flow-shower-fixture.1519/. I have also attached the picture from the linked thread to help.
