• Click here to access some of the presentations made during the 2022 National Rally

No power to camera wiring

Vapors56

New member
Went to install a rearview camera and there's no power to the wiring behind the plug high on the back of the unit. Camera switch is "ON". I've checked the wires with a mutimeter. Does anyone know which fuse controls that wiring? Or, have any suggestions for what else might get it working? Thanks.
 

Vapors56

New member
Situation solved. I contacted Alliance via email and, after a couple of emails, they suggested pulling off the switch control panel to see if the switch wires were disconnected. That was the problem: one of the wires wasn't connected to the switch terminal. There was another switch that had a nearly disconnected wire there also. Obviously, this shouldn't have happened but it's something you can check (besides the fuses) if you have a DC circuit that's not working.
 
Top